T2,
T25, and T28 Rebild Kits
These rebuild
kits are for non
ball-bearing
turbos only. Ball-bearing turbo rebuild kits are currently not
manufactured. If you are not sure whether you have a ball bearing turbo
or not, email us your turbo part # which is located on the bearing
housing/center section of the turbo, or we could also identify the
turbo in most cases by the vehicle's year, model, and engine code (when
applicable).
There are two different types of compressor end seals used on T2, T25,
and T28 turbos. The choices are dynamic
seal or carbon
seal kits. From
our experience, almost all of the T25's made from 1990 and up are the
dynamic seal type. Most turbos made before 1990 have a carbon seal.
Below is a picture of the different seals, and a list of which vehicles
used what type of seal.
T2, T25. and T28 Dynamic Seal
Complete Rebuild Kit
| #1 |
Journal Bearings , 2 Sets
(Narrow & Wide) |
| #2 |
Retaining Rings for
Journal Bearings |
| #3 |
Retaining Ring for Oil
Deflector |
| #4 |
Oil Deflector Seal/Washer |
| #5 |
Piston Ring for Turbine End |
| #6 |
Thrust Bearing |
| #7 |
Bolts for Thrust Bearing |
| #8 |
Seal Ring for Seal Plate |
| #9 |
Thrust Collar |
| #10 |
Piston Ring for Compressor
End |
| #11 |
Seal Plate |
| #12 |
Retaining Ring
for Seal Plate |
| #14 |
Locknut for Turbine Shaft,
0.264" (6.70mm) |
| #16 |
O-Ring for Compressor
Housing |
| #17 |
Retaining Ring for Swing
Valve |
| #18 |
Retaining Ring for Turbine
End |
| #19 |
Bolts for Turbine End |
| #20 |
Clamps for Turbine End |
T2, T25. and T28 Carbon Seal
Complete Rebuild Kit
| #1 |
Journal Bearings , 2 Sets
(Narrow & Wide) |
| #2 |
Retaining Rings for
Journal Bearings |
| #3 |
Retaining Ring for Oil
Deflector |
| #4 |
Oil Deflector Seal/Washer |
| #5 |
Piston Ring for Turbine End |
| #6 |
Thrust Bearing |
| #7 |
Bolts for Thrust Bearing |
| #8 |
Seal Ring for Seal Plate |
| #9 |
Thrust Collar |
| #11 |
Seal Plate/Carbon Seal
Assembly |
| #13 |
Thrust Spacer |
| #14 |
Locknut for Turbine Shaft,
0.264" (6.70mm) |
| #16 |
O-Ring for Compressor
Housing |
| #17 |
Retaining Ring for Swing
Valve |
| #18 |
Retaining Ring for Turbine
End |
| #19 |
Bolts for Turbine End |
| #20 |
Clamps for Turbine End |
